This is a 79 piece model of the Tyrannosaurus Rex 3D Printed Kit. It is printed with PLA Plastic with 2 parameters and 10% infill. Item weighs about 1 lb. The base and post to hold the skeleton upright is printed in black or brown. Total length is 24″ with the height of 9.5″ and width of 3.5″. The skeletons are snapped into place and does not require gluing however if you plan on transporting the model around, we recommend that you glue it in place with a plastic-friendly craft adhesive. Take caution when assembling the model, do not apply excessive force when pushing the pins as they will break. We recommend that you use a long and pointy needle nose pliers to push the pins into place. Please note that this model is 3D printed and will require some clean up when assembling the model. The pins and ribs will come attached to a peel-able plastic sheet. This is to keep all the ribs aligned properly for easy assembly however if they pell off the sheet during shipping, they have numbers to go alone with the instructions. Again, use needle nose pliers to peel the ribs and pins. This model is recommended for ages 16 and up, children should be supervised by adults.
Color selection is for the Tyrannosaurus Rex skeleton only. If you would like it to match then please leave us a note else, we will ship in a black or brown base. If you have a preference, again, leave us a note. Item has a one week lead time.